This is the one use for the Pinch-pop that can be used to enhance a sculpture.
Inflate the balloon to about 18-20 inches. Twist a 1.5 inch bubble followed by a 5-6 inch bubble. Make a Loop Twist in the larger bubble and tuck the smaller one inside the loop. This makes the rear tire (with a valve stem!).
Make a 2-3 inch loop twist for the luggage rack/seat back and a 3-inch bubble for the body.
Next make a 5-bubble loop of 1-5 inch bubbles for the handlebars.
Make a Pinch-pop from the three middle bubbles to separate the handlebars.
Next, comes a small Pinch Twist for the headlight and a larger pinch twist for the gas tank.
The rest of the balloon will be the front fork and tire. The front fork is a single bubble, made to a length that will leave about 6-7 inches for the front tire.
The front tire will be a loop twist with a 1.5-inch bubble tucked into the loop, similar to the rear tire.
